Cleaning and maintenance of bicycle parts

After cleaning the exterior of the bicycle parts, cleaning, attention to the need to remove dirt and residual oil, etc.. If necessary, wholesale bicycle  parts suppliers after the demolition of the cleaning and maintenance, pay attention to put the bicycle fittings removed parts on the bench or stent, in order to further the parts stripped for parts, components is split into parts should be mark on the parts, can avoid the parts to confuse, inconvenient assembly and cause a lot of trouble.

Triangle reinforced sheet for electric vehicle stamping part

From bicycle spare parts, remove bolts, nuts, washers and other parts should be placed in kerosene or hot soda solution cleaning, all the parts clean up after, to re assemble the way back before the bicycle accessories used, each part must be installed in the same place, and the trial run is normal, regular in accordance with the provisions to bicycle fittings to do maintenance can improve its performance, and prolonging the service life of the.